How to Replace the Door Boot Seal on an LG Washer

Introduction

• Presenter: Simon from AppliancePartsPros.com
• Purpose: Guide on testing and replacing the door boot seal on an LG washer
• Issues Indicating Replacement Needed:
  • Water leaks from the front
  • Musty odor
  • Visible mold/mildew

Tools and Safety

• Tools Needed:
  • Phillips screwdriver
  • Adjustable pliers
  • Flathead screwdriver
  • Side cutters
  • Zip tie
  • Door boot seal clamp removal tool
• Safety Precautions:
  • Unplug washer
  • Turn off water supply

Steps for Removing the Old Door Boot Seal

1. Prepare the Washer

   • Open filter door at the bottom left
   • Pull drain hose from clip
   • Remove screws near filter with Phillips screwdriver
   • Pull out the white housing

2. Access the Back of the Washer

   • Remove two bottom screws from the top panel
   • Slide the top panel back and remove

3. Remove the Control Panel

   • Pull out detergent dispenser
   • Remove screws from dispenser opening
   • Remove screw from right side corner
   • Release clips along the top edge
   • Disconnect plugs and remove control panel

4. Remove the Front Panel

   • Open washer door
   • Use flathead screwdriver to remove retainer spring
   • Pull door seal off the lip
   • Remove screws holding door latch
   • Remove six screws from top edge
   • Lift front panel from bottom hinges

5. Detach Hoses

   • Remove screws and clamps from hoses on sides and bottom
   • Remove black hose clamps at the top
   • Disconnect light on top left

6. Remove Old Boot Seal

   • Use clamp removal tool to detach clamps and retainer ring
   • Remove boot seal from tub lip

Installing New Door Boot Seal

1. Install New Seal

   • Push out dual hose adapter from old seal
   • Apply soap and install adapter onto new seal
   • Apply soap to seal groove and fit onto tub lip

2. Attach Retainer Ring

   • Place inner retaining ring in groove
   • Use boot seal clamp tool to secure spring
   • Check installation

3. Reconnect Components

   • Connect black hoses and secure clamps
   • Secure plastic retainers with screws
   • Reinstall and secure light with zip tie

4. Reassemble Washer

   • Reattach front panel and secure with screws
   • Reinstall door latch
   • Fit boot seal on outer lip and secure with retainer spring
   • Ensure everything is fitted correctly

Final Steps

• Reassemble Parts:
  • Install screws in filter door and pump
  • Secure control panel and reinstall detergent drawer
  • Align and secure the top panel
• Check Functionality:
  • Turn on water supply
  • Check for leaks
  • Plug washer back in

Conclusion

• Encouragement: Great job on completing the repair!
• Additional Tips: Share stories or tips in comments
• Where to Buy Parts: AppliancePartsPros.com with model number

Reminder

• Like and Subscribe: For more appliance repair guides