Lecture Notes

Subject: Use of Revolve Feature in Modeling

Introduction

• Main Objective: To create a revolve component.
• Initial Preparation: Create a center line and draft different parts.

Step 1: Revolve Basic Shape

1. Create a Center Line:
   • Center Plane: Use the front plane.
   • Origin: Central point (middle).
2. Dimension Setup:
   • Bottom part: 11
   • Top part: 12
   • Middle part: 9
   • Total length: 25 (center at 18)
   • Inner part: Diameter 10
3. Use Revolve Feature:
   • Revolve the draft.

Step 2: Second Revolve Processes

1. Create Center Line Again:
   • Reuse the previously set 18 points.
   • Create a new draft and use revolve.
2. Dimension Setup:
   • Back part: 8.5
   • Diameter: 10
   • Total length: 12

Step 3: Internal Cutting

1. Internal Cutting:
   • Set taper and angle.
   • Important Dimensions:
     • Angle: 59 degrees (half of 118 degrees)
     • Middle diameter: 5
     • Total length: 20.5
2. Revolve Cut: Cut the entire sketch using revolve cut.

Step 4: External Cutting

1. External Cutting:
   • Draw a new sketch (straight rectangle).
   • Dimension and revolve cut.
   • Create V shape with the same diameter intersection.

Step 5: Making Holes

1. Hole Process:
   • Draw a rectangle with 3.5 width and 2 depth.
   • Use break cut.

Step 6: Chamfer

1. Chamfer Process:
   • Apply chamfer on the front plane sketch.
   • Set various dimensions:
     • 1.5 (half), 7.5, 5, 4.5

Conclusion

• Modeling: How to use the revolve tool to create a model.
• Shapes and Cuts: Properly applying shapes and cuts.
• Video Suggestion: Subscribe to the channel and like the video.
• Wrap-Up: Model is ready.

Finally

• Will meet again with a new video.
• Jai Hind, Vande Mataram.