Notes on Replacing AC Compressor, Dryer Tube, and Expansion Valve in a 2015 Nissan Rogue

Introduction

• Task: Replacing AC compressor, dryer tube, and expansion valve.
• Vehicle: 2015 Nissan Rogue.

Preparing for Compressor Removal

• Refrigerant Check:
  • If refrigerant is present, it needs to be drained (suggest taking it to a shop).
  • Begin by removing two 10mm bolts for line access.
• Wire and Bolt Removal:
  • Disconnect the wire and loosen the two bolts on the compressor.

Accessing the Wheel Well

• Steering Wheel Adjustment:
  • Turn towards the passenger side for easy access.
• Removing Wheel Well Liner:
  • Take off plastic liner for serpentine belt access.
  • Use a T20 to remove star screws and few snaps from the liner.

Removing the Serpentine Belt

• Use a 14mm socket to remove the belt.

AC Compressor Bolt Removal

• Access from below the vehicle without jacking it up.
• Locate and remove bolts with a ratchet.
• Move to the top of the engine to extract the compressor.

Radiator Fan Removal

• Issue: Tight space for compressor removal; removing radiator fan.
• Disconnection Steps:
  • Remove wire harness and screws.
  • Disconnect the radiator hose if necessary (caution to avoid coolant spills).

Compressor Oil Adjustment

• New compressor comes with 7 ounces oil; vehicle needs around 3.5 ounces.
• Drain existing oil and refill with correct amount (3 ounces).

O-Ring Replacement

• Replace two O-rings on lines to compressor.

Reinstalling Compressor

• Reinstall compressor in reverse order.

Replacing Dryer Tube

• Access:
  • Remove vehicle grill by loosening clips.
  • Access to dryer’s 10mm bolt through radiator mount manipulation.
• Removal of Dryer:
  • Disconnect electrical connector and 10mm bolts.
  • Replace O-rings on lines.

Installing New Dryer Tube

• Switch over the sensor and bracket from old to new dryer.

Accessing and Replacing Expansion Valve

• Access:
  • Remove 10mm nut and vacuum line to access connectors.
  • Detach hoses for access.
• Removal:
  • Remove 25mm Allen screws to extract valve.
  • Careful not to damage components in case of reinstallation need.

Refilling Refrigerant

• Preparation:
  • Check system for leaks before refilling.
  • Use 18 ounces (just under two cans) of refrigerant.
• Filling Process:
  • Add refrigerant while monitoring for leaks.
  • Start vehicle to complete filling process.

Conclusion

• Testing:
  • Check if AC is functioning properly (cold air inside vehicle).
• Final Checks:
  • Ensure AC lines are cold.

Closing

• Video helpfulness and feedback invitation.
• Encourage likes and comments for further assistance.