Oil Change Guide for Prado 150

Introduction

• Short video on conducting an oil change on a Prado 150 (2015 model)
• Aimed at saving money compared to mechanic services (approx. $100-$300)

Cost Considerations

• Mechanic charges about $100 for an oil change (1-1.5 hours of work)
• DIY cost:
  • 7 liters of Penrite 10W-40 oil: $82.99
  • Cooper oil filter (WZ-418): $20
  • Total DIY cost: $102.99

Tools and Equipment Needed

• Ramps for better access (optional)
• 12mm socket for removing the protective plate
• 14mm socket for the sump plug
• Rag for cleanup
• Funnel for pouring new oil

Steps for Oil Change

1. Preparation:

   • If using ramps, ensure they are stable.
   • Gather tools and materials.

2. Accessing the Sump Plug:

   • Remove the protective plate using a 12mm socket.
   • Locate the sump plug (14mm socket required).

3. Draining Old Oil:

   • Use the 14mm socket to remove the sump plug (be cautious of hot oil).
   • Allow old oil to drain for about 15 minutes.

4. Changing the Oil Filter:

   • Identify the oil filter on the passenger side (blue filter).
   • Use an oil filter wrench to remove the old filter.
   • Apply a small amount of new oil on the rubber seal of the new filter before installation.
   • Tighten the new filter by hand, ensuring it is secure but not over-tightened.

5. Refilling New Oil:

   • Replace the sump plug securely.
   • Pour 7 liters of new oil using a funnel into the engine.
   • Check the oil level using the dipstick and adjust if necessary.

6. Final Checks:

   • Replace the protective plate.
   • Check for leaks around the sump plug and filter.
   • Clean up any spills and dispose of old oil responsibly.

Maintenance Tips

• Recommended oil change interval: every 5000 km.
• Regular checks while under the vehicle for any damage or leaks.

Conclusion

• DIY oil change is a cost-effective skill to learn.
• Enjoy the savings and the satisfaction of maintaining your vehicle.

Final Reminders

• Always ensure tools are cleaned and stored away after use.
• If unsure about any steps, consult a mechanic.