Question 1
What kind of welding should be done initially to hold the truss in place during assembly?
Question 2
What should be done next after the disassembly of the axle?
Question 3
How much weight is approximately removed during the disassembly process?
Question 4
What size tire can the 2005+ Dana 60 axle handle?
Question 5
What axles are 2005+ Dana 60 axles a factory option for?
Question 6
What is an important step when handling the ABS sensor?
Question 7
What is a key benefit of reverse cut gears in the Dana 60?
Question 8
What should be used to clean the assembly area for better welding results?
Question 9
What spline count does the 2005+ Dana 60 axle come with for both inner and outer shafts?
Question 10
Which component is used as a truss in this installation?
Question 11
What must be removed after taking out the brake rotor?
Question 12
What is one benefit of reverse cut gears besides better contact and driveline angles?
Question 13
Which tool might be necessary to remove the snap ring during disassembly?
Question 14
What is the primary reason for upgrading to 35 spline shafts?
Question 15
What kind of bearing bolts need to be undone to pry out the axle shaft?