Assembling and Installing a Musty Laundry Sink

Presented by Kerry

Components Provided with the Sink

• Four legs
• Leveling feet
• Leveling hardware for the feet
• Drain stopper
• Nut for the p-trap

Additional Purchased Component

• 4-inch spread laundry faucet
  • Supply lines
  • Plastic gasket
  • Inlet nuts
  • Hex wrench for cartridge removal
  • Hose threads on the end of the spout

Assembly and Installation Steps

1. Preparing the Sink

• Lay the sink on its top.
• Drill holes on the ledge for the faucet spreads.
  • Use a 1-inch hole saw with a cordless drill.

2. Attaching the Legs

• Place the sink on the cardboard it came in.
• Push the four legs into the grooves on the bottom of the sink.
• Use a block of wood and hammer to tap the wood and seat each leg properly.

3. Installing Leveling Feet

• Install one foot into each leg using screws and nuts provided.
• Flip the sink upright.

4. Installing the Faucet

• Place the plastic gasket over the drilled holes on the ledge.
• Remove supply covers.
• Insert the faucet through the holes.
• Spin one mounting nut onto each inlet to secure the faucet.
• Thread the red stripe supply line onto the hot water inlet.
• Repeat for the blue stripe supply line for the cold water inlet.
• Note: Rubber gaskets inside the connectors mean thread tape is not needed.

5. Connecting the Sink

• Move the sink into position by the washer and dryer.
• Thread the 3-8 compression nut from the supply line onto the fitting of the hot water supply valve.
• Repeat for the cold water supply line.
• Open each supply valve and check for leaks.

6. Connecting the P-Trap

• Connect the P-trap to the sink.

Final Check

• Turn on the water and check for leaks in the drain lines.

Tools Needed

• Hammer
• Drill
• Hole saw
• Adjustable wrench
• Level

Time Allowance

• At least an hour for assembly and installation.
• More time may be needed if the drain lines are not in place.

Completion

• Thank the audience for watching.