Active 2.0 Pressure Washer Support Video Notes

Introduction

• Presenter: RO from Active Products
• Purpose: Troubleshooting Active 2.0
• Focus: Setup, Operation, and Storage

Setup Instructions

High Pressure Hose Connection

• Pump Outlet: Locate the anodized male threaded connection and connect the hose clockwise, hand tighten.
• Gun Inlet: Connect the hose to the anodized connection at the bottom of the gun, turn until resistance is felt.

Garden Hose Connection

• Water Inlet: Locate the female brass connector and attach the garden hose, tighten until resistance.
• Important: Ensure water supply is on before starting to avoid damage.

Wand and Spray Tip

• Wand Attachment: Connect the threaded end of the wand to the gun, turn counterclockwise.
• Spray Tip Connection: Slide back the collar of the wand, insert the spray tip, release collar to lock.

Power Supply

• Ensure unit's power switch is off.
• GFCI: Built-in for safety, press and release test button to ensure light is on.

Purging the Unit

• Purpose: Remove air from lines.
• Release trigger safety, press trigger for a steady stream of water, then turn on power switch.

Operation

• TSS Technology: Motor shuts off when trigger is not engaged.
• Switching Spray Tips:
  • Engage Safety Lock, change spray tip, disengage Safety Lock.
• Foam Blaster Connection:
  • Remove wand, attach foam blaster by turning counterclockwise, fill with detergent, apply to dry surface.

Shutdown Process

• Turn off water supply.
• Pull trigger to release water pressure.
• Turn off power switch, unplug unit, and engage Safety Lock.
• Disconnect hoses and accessories for storage.

Winterization

• Antifreeze Process:
  • Connect antifreeze canister, press button till fluid exits hose, remove hose from pump inlet.
• Alternative Process:
  • Disconnect water connections, run unit for a few seconds to clear water, store in non-freezing environment.

Storage Tips

• Avoid storing near heat sources to prevent drying of internal seals.

Conclusion

• For further assistance, contact [email protected]
• Video end and farewell.